Technical Information Technical Information-
M23: Signal Connectors


M23 Control "Signal Connectors" Materials & Technical Information
 

Housing

Brass Die Casting (Copper-Zinc-alloy Ms58)

CuZn39Pb3

GDZnAL4Cu1

Housing Surface Nickel plated brass
other surface finishes upon request
Inserts (for contacts)
Thermoplastic Polyamide PA 6 (Nylon 6/6) PBT

Fire protection class V-0

Contacts

Brass Alloy Ms 58 / Ms 60 Pb

CuZn39Pb3 / CuZn38Pb1,5

Seal / O-Rings Nickel and gold plated (0,25 mm thick)
Minimum mating cycles >1000
Seals / O-Rings Buna-N standard optional Viton (Viton is a registered trademark of DuPont)
Temperature range -40 C to 125 C (-40 F to 257 F)
Type of Contacts Crimp, Dip-solder (PCB)
Protection IP 67 per DIN 40 050 (Connected) (NEMA 4x)
Cable diameter range

3-14 mm (0.12-0.55")

 

Electrical Data

Number of positions 6 7 9(8+1) 12 16 17 19(16+3)
Number of contacts 6 6  8       1 12 16 17
16

3

Contact- [mm] 2 2 1       2 1 1 1
1

1,5

Rated current 1) [A] 20 20 8     20 8 8 8
8

10

Rated voltage 2) [V~] 300 300 300 300 150 150 150
Test voltage 3) [V~] 2500 2500 2500 2500 1500 1500 1500
Insulation resistance [MW] > 1010 > 1010 > 1010 > 1010 > 106 > 106 > 106
Max. contact resistance [mW] 3 3 3 3 3 3 3
Level of Accumulation 4)  3 3 3 3 3 3

 

1) Nominal Current: Allowable current (Amp), which can be transmitted by each contact continuously and simultaneously.
2) Nominal Voltage:  Allowable Voltage (Volt), which can be applied to each contact continuously and simultaneously.
3) Test Voltage: Voltage which, under certain conditions, a connector can be exposed to without breakdown.
4) Level of Dirt Accumulation:  Potential dirt accumulation of a disconnected Connector in a certain environment.

Level of Dirt Accumulation 2:

No permanent conductive dirt accumulation will occur.  Temporary conductive dirt accumulation, such as condensation, is possible.  Typical for households, offices, laboratories and test labs.

Level of Dirt Accumulation 3:

Conductive, as well as dry non-conductive dirt accumulation can occur.  It can be temporary conductive due to condensation.  Typical for industrial and factory environments.

Contacts & Configurations


| Home | Benefits and Features | Connector Assembly Instructions | Crimp Assembly & Disassembly |
| Technical Information | Product Selection | Request For Information | How To Order | Cross Ref |

 

Toll Free: 888-453-3848 / 514-453-3848  Fax: 514-425-2404